Hi, here are some strange things I've come across. I used the latest free version on PC in Reaper.
1. Switching to the less sensitive mode by holding the Shift key doesn't work.
2. Sound editor. Velocity offset doesn't make any difference. A program always plays starting from 1 velocity.
3. Numerical parameters with the initial value of 0ms are stuck at 0ms and cannot be click-dragged to slide their values up/down. First, I must double click on it to enter any value, then I can click and drag it. However, if I accidentally drag it to 0 ms, it will get stuck again. Dials work fine except fine-tuning by Shift+dragging.
4. Both BiQ and SVF. There is no any difference between 6 and 12db slope of LowPass filter.
5. In serial mode, SVF Allpass works like the Notch filter.
6. SVF/Bell. The flat freq. responce is at Drive = -60%, not at 0%. Is it on purpose?
7. BiQ/Peak and SVF/Bell are the only two filters where the Drive parameter works according to the manual. In the rest of filters it rather cuts/boosts bottom and top frequencies.
8. The Tart filter works like a Lowpass with Res changing signal volume. Does it work like that? I have never heard of such a filter.
9. SVF/Low&HighShelf. The flat freq. responce is at Drive = -60%. Again, I'd expect it to be at 0%.
To test all that, I used a single saw oscillator program and Freq. analyzer.
Questions.
Should the Setting>Default Quality Mode effect the oscilators aliasing and filter responce shape at high frequencies? Currently, it doesn't.
If it's not hard, could you please exclude 6db slope option from filters where it is not used to avoid false expectations? I know, the manual mentions that, and yet...
Thanks,
Vitaly.
1. Switching to the less sensitive mode by holding the Shift key doesn't work.
2. Sound editor. Velocity offset doesn't make any difference. A program always plays starting from 1 velocity.
3. Numerical parameters with the initial value of 0ms are stuck at 0ms and cannot be click-dragged to slide their values up/down. First, I must double click on it to enter any value, then I can click and drag it. However, if I accidentally drag it to 0 ms, it will get stuck again. Dials work fine except fine-tuning by Shift+dragging.
4. Both BiQ and SVF. There is no any difference between 6 and 12db slope of LowPass filter.
5. In serial mode, SVF Allpass works like the Notch filter.
6. SVF/Bell. The flat freq. responce is at Drive = -60%, not at 0%. Is it on purpose?
7. BiQ/Peak and SVF/Bell are the only two filters where the Drive parameter works according to the manual. In the rest of filters it rather cuts/boosts bottom and top frequencies.
8. The Tart filter works like a Lowpass with Res changing signal volume. Does it work like that? I have never heard of such a filter.
9. SVF/Low&HighShelf. The flat freq. responce is at Drive = -60%. Again, I'd expect it to be at 0%.
To test all that, I used a single saw oscillator program and Freq. analyzer.
Questions.
Should the Setting>Default Quality Mode effect the oscilators aliasing and filter responce shape at high frequencies? Currently, it doesn't.
If it's not hard, could you please exclude 6db slope option from filters where it is not used to avoid false expectations? I know, the manual mentions that, and yet...
Thanks,
Vitaly.
Statistics: Posted by Vitaly — Thu Jun 06, 2024 4:40 am