I have just come across the same this morning when going to try the sequencer.Hm, I don't understand this ...
In the Manual (p. 56) it says:
PRESET
Factory presets or user-generated presets can be loaded into the sequencer by clicking on the
display above PRESET. This will prompt a dropdown menu with three choices. These are covered
below.
● Load Midi File - Choose a MIDI file from a hard drive as the basis of a sequence. As mentioned
above, MIDI files should contain only a single track and be monophonic.
● Patterns - Choose from one of The Legend HZ's 20 preloaded sequencer patterns.
● Unload Midi File - Clears the MIDI pattern currently in use. This function only appears after
a MIDI file has already been loaded (you should see a pattern on the display to the right).
When I click on that display above PRESET, I am offered these two choices:
● Load Midi File
● Initialize Sequencer
Also, clicking on either of the PRESET arrows below the display doesn't have any effect.
Where are those 20 sequencer patterns stored?
For instance, there is a preset patch called "Base Tech KS HZ", which makes use of the sequencer. The display shows "Pattern 19". Again, clicking on either of the PRESET arrows below the display doesn't have any effect, so neither can you skip to a "Pattern 18" nor to a "Pattern 20".
I see that there is an "ArpMidi" folder in Documents (Windows), but it is empty. Is this because it is just for USER MIDI files?
For example, there is a preset patch called "Colors KS HZ", which makes use of a MIDI file called "TheSearch01". Is that stored anywhere? How could I exchange it for, let's say, "TheSearch03" (which does exist and is used in another preset patch)?
What am I doing wrong here, or, what do I misunderstand?
I don't have a solution but have emailed synapse to find out about it.
Statistics: Posted by Samiver — Sun May 05, 2024 7:42 am